Solution for partially filled pipes

  • Measurement in partially filled pipes up to DN1600 / 64″
  • Patented, non-contact level measurement
  • Measurement possible down to 10% filling of pipe
  • Sensor and converter available in Ex zone 1

The TIDALFLUX 2000 flow sensor with integrated and non-contact capacitive level measuring system provides accurate flow measurement in partially filled pipes.

TIDALFLUX is designed to measure reliably between 10% and 100% of the pipe cross section. The integrated level sensors in the liner are in no contact with the liquid and are therefore insensitive against fat and oil floating on the surface.


  • For partially filled pipes in the water and wastewater industry
  • Broad diameter range up to DN1600 / 64″
  • High abrasion resistance and chemical resistance
  • Measurement possible between 10% and 100% filling
  • Electrodes for flow measurement are below 10% filling level, therefore no
  • blind folding by fat and oil floating on the water surface
  • Complete factory calibration – no on-site calibration necessary
  • Water
  • Wastewater
  • For partially filled pipes instead of expensive siphon tube constructions
  • Water and wastewater
  • Surface water

Biological and chemical wastewater

Leave a Comment

Your email address will not be published. Required fields are marked *